The following items make the 48-inch x 48-inch Threaded Cross Feed Slab Mill:
- Three (3) 55 inch length RGS guide rails
- One (1) 55 inch length RGS Guide rail, with the threaded rod kit installed
- Four (4) 6-inch length self-aligning dovetail connectors, with set screws installed
- Eight (8) Bearing End Caps, installed on rails with 10-24 Type F Machine Screws
- Two (2) Short Linear Slides (Short Runners) with bubble levels installed
- Two (2) Long Linear Slides (Long Runners)
- Two (2) Drop Downs
- One (1) Router Base Plate, pre-drilled for listed routers (see compatibility below)
- Fourteen (14) 10-24 threaded, 1/4 inch diameter, 1/4 inch length Shoulder Bolts
- Six (6) 8-32 x 1/2 L flat head Phillips drive machine screws
- One (1) 1/8 inch L-shaped hex wrench
- Two (2) Hand Grip Knobs
If the Threaded Cross Feed version is chosen, one of the 55-inch extrusions above will have the 55-inch Threaded Rod Kit installed. Additionally, two (2) knurled brass thumb screws will be included with the standard hardware packet as well as one (1) hand crank to attach to the threaded rod.
The Threaded Cross Feed units can be moved manually without the rod or hand crank by simply removing the two thumb screws and moving the Router Base Assembly by hand.