RGS - 27-1/2" Threaded Rod Kit (22 Inch Capacity)
-
This kit allows the addition of a threaded rod to an existing 27-1/2 inch long Router Gantry System Rail.
-
Effectively, this for creating the threaded index control on a 22 inch working area capacity "bridge" unit.
-
Includes the threaded rod itself, two permanently sealed press-fit bearings, and two Acme-threaded nuts already spaced and installed on the rod.
-
90-Day Money Back Guarantee
-
Lifetime Warranty
-
Unlimited Phone & Email Support
-
Clean, Consistent Cuts Every Time
-
Precision Tools, American Made
Easily control the placement of your router across the width of a 22 inch wide capacity unit with this threaded rod kit.
-
This kit is meant for use within a 27-1/2 inch long Router Gantry System extruded rail.
-
Bearings are press fit onto the rod and will fit within any RGS Bearing End Cap.
-
Spacing between the two Acme Nuts is 4-1/4 inches on center.
Materials Used
- 1/2 - 10 Acme Threaded Rod, low carbon steel, RH thread pitch, roll formed by Keystone Threaded Products in Independence, OH
- 1606-2RS sealed deep groove ball bearings, press fit onto each end of the Acme rod
- Custom machined Acme nuts, with brass threaded inserts
- Bakelite hand wheel
- Knurled brass thumb screws for easy engagement
This kit includes the following:
- One (1) 29-7/16 in. length Acme threaded rod
- Two (2) 1606-2RS sealed ball bearings, installed
- Two (2) Acme Nuts, installed
- Two (2) Knurled brass thumb screws
- One (1) Bakelite hand wheel
For use with the TrueTrac Router Gantry System, to convert a Manual Feed unit into a Threaded Cross Feed unit.
- Not compatible with products produced by other companies.
