It took me about an hour to set it up. I drilled the plate mounting holes from the bottom ,plate, side, seemed easier to me. I countersunk the mounting screws in the plate. I checked the plate to blade with the included jig and a small flashlight after every drill and screw. I broke down a full sheet of plywood and checked every cut with a Starrett tape measure and a framing square and everyone was perfect. I don't do much sheet goods, mostly hardwood, but this thing is excellent at sheet goods. I just lay the sheet on an old piece of 3/8 inch, support the overhang, make one small mark on each side of the sheet, set the track on the sheet on the marks, set the saw on the track and saw. I keep my left hand on the left side of the track just to know if the track shifts, it never does. I set the blade 1/16 lower than the thickness of the sheet. i think what amazes me is you just lay the sheet down and cut it, no fence no miter gauge, just a tape measure and pencil. 8 pieces all told.
Such a great system. Really works great w my Triton and leaves the slab so much smoother than my previous set up. Greatly reduced my sanding times after flattening so I can get to the fun stuff! Great product and Jacob did a great job communicating during a supply chain issue. Higy recommend him and the product.
This is a well made storage device and I can easily keep all the gear in the bag for easy transport.
Thank you for the caring and good service, I have never been so impressed, with the good products and very good quality. Thank you again.
Jacob, these clamps make using the track saw attachment a breeze. Use them on everything I build that has a straight side too it.