Square Pkg #1
This track saw kit includes a TrueTrac Simple Square kit and a 24 inch section of the TrueTrac Pro-Series track.
Please select which variant of the Simple Square track saw guide you require with the drop-down menu above - Looking from the rear of your saw, "Right-Blade" has the saw blade to the right side of the saw body, and "Left-Blade" has the blade to the left.
- 90-Day Money Back Guarantee
- Lifetime Warranty
- Unlimited Phone & Email Support
- Clean, Consistent Cuts Every Time
- Precision Tools, American Made
Fully CNC machined on all six sides from 6061-T6 aluminum Glass-bead blasted for final surface finish
This product includes:
- One (1) 24-inch length Pro-Series Guide Rail
- One (1) 16-inch length Simple Square Body
- Four (4) 1/4-inch diameter, 5/16 inch length, 1/4-20 threaded shoulder bolts
- Two (2) 12-inch length Simple Square connectors, with set screws installed
- One (1) L-shaped hex wrench
- Installation instructions
To sum up the tile it’s just easy to use. The Datto jig works awesome as well and I can’t to get my new shop built and purchase the slab flattening device. Good quality stuff
By careful assembly, checking using an accurate right-angle, no further adjustments were required: the critical step was cross tightening the bolts in an iterative manner while the trac and handle were held clamped in position at 90 degrees. The bolts were a tight fit, but no adjustments of materials were required. Clamping during assembly avoided any play, and right-angle accuracy was preserved when the clamps were removed. An absolute delight to use.
I ordered the Simple Square kit that contained a 24" section of track. Everything was delivered and it was well packaged. I followed the instructions and had a little trouble getting it square. I loosened all 8 bolts and seemed to have succeeded in achieving a good 90 degree position. But when I went to use the Simple Square to square up a new board, I found it was off again. I have a panel T square for a reference and it is accurate. So I followed the alignment directions again. I found that every time I tightened the shoulder bolts, the square would revert to its original position. I reamed out the 4 bolt holes in the handle to get some adjustment clearance. This time it squared up easily and stayed square after tightening the bolts. I have used it about 10 times since and so far it has remained accurate. I believe the shoulder bolt holes did not allow enough clearance for adjustment as they came from the factory. Reaming them ever so slightly has made the difference. I am pleased with the Simple Square and will use it whenever I need it. I will check it for accuracy before using but I am confident it will be fine.
This product is designed for use with the TrueTrac Pro-Series circular saw guides.
This square is not designed to work with competitive systems - Festool, Makita, DeWalt, Wen, Kreg, etc, as all of those tracks lack the dovetail connector grooves used for alignment.